![]() ![]() Most of the routers that are in use out there will make a Class C network which will give 256 addresses. For this example, I am going to use a router with an address of 192.168.1.1. ![]() The IP address range is set by your router, the most basic off the shelf routers will have an IP address itself of 192.168.0.1 or 192.168.1.1. The most common network addresses that we see are between the ranges of IP address stands for Internet Protocol Address, specifically IPv4, and is a numerical address for each device on a network. The most important part of the networking side of the X32 are the addresses. ![]() The network for the Behringer X32 WiFi Setup is using the same technology as your computer or laptop. If you wanted to add more ports to connect more devices, you would use the network switch. We typically will find a ‘wireless router’ to not only allow physical connections with network cables but also allow wireless devices like phones or tablets to connect as well.Ī network switch gives the ability to expand the physical network connections as your wireless router will have 4 LAN ports on it. With the X32 we can use CAT5, CAT5e, and CAT6 cables for the network interface.Ī router is the device that gives out IP addresses to everything on the network and is the main brains of the network. A CAT5e cable stands for the type of network cable it is. Moving on to the basics of networking, let’s talk about the hardware of networking and wifi.Ī network in the old days was only connected with network cables, what we refer to as CAT5e cables. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |